- Features:
- Cut-n-splice to desired length
- Made in the U.S.A.
-
PRODUCT NAME CABLE KIT TYPE EXTENSION COLOR/FINISH BLACK WIRE/CABLE LENGTH (18") / 18" WIRE GAUGE 16 AWG UNITS KIT
Shop Fat Baggers Motorcycle Products
-
WIRE EXTENSIONS FOR H-D HEATED GRIP WORKS WITH 12"-18" BARS -
97-08 Docking Kit for Overlay Fenders
-
This part is used to replace the stock plastic housing that comes factory on H-D bikes. Features:- Aluminum upgrade
- Powdercoated finish
-
EZ Clutch Adjustor Upgrade Kit- The NEW EZ Clutch Adjustor Upgrade Kit converts the factory upper clutch cable adjustor to a screw type adjustor while reinforcing the cable.
- The adjustor also works as a repair part for broken H-D factory cable adjustors.
- Works with stock cables and Fat Baggers' Ez Clutch Extensions.
- Dimensions: 1/2-20 threaded split adjustor.
- MADE IN THE USA!
- This product is for 2021 FLHT, FLHTK, FLHX, FLHXS, FLHXSE, FLHTKSE, FLHTCUTG, FLHTCUTGSE, FLTRK, FLTRXS, FLTRX, FLTRXSE, FLHR, FLHRXS, (Cable Clutch Models), and 18-23 Softails.
-
EZ Clutch Adjustor Upgrade Kit- The NEW EZ Clutch Adjustor Upgrade Kit converts the factory upper clutch cable adjustor to a screw type adjustor while reinforcing the cable.
- The adjustor also works as a repair part for broken H-D factory cable adjustors.
- Works with stock cables and Fat Baggers' Ez Clutch Extensions.
- Dimensions: 1/2-20 threaded split adjustor.
- MADE IN THE USA!
- This product is for 2021 FLHT, FLHTK, FLHX, FLHXS, FLHXSE, FLHTKSE, FLHTCUTG, FLHTCUTGSE, FLTRK, FLTRXS, FLTRX, FLTRXSE, FLHR, FLHRXS, (Cable Clutch Models),
-
Features:- Includes 26-OEM color matching wires
- Male & Female terminals are installed using MIL-SPEC machinery
- Comes with 26-pieces of 3/16″ OD heat shrink for the terminals and 1/2″ shrink for the loom
- Made in the USA
-
Features:- (24”) 26-wires, color matching & heat shrink. USE: Should be installed when wiring is routed through handlebar. NOTE: Terminals are installed on one end only for easy splicing.
- Made in the USA
- 2007-2013 Bagger Models
-
Features
- This handlebar wiring extension is used to extend the wiring to a set of OEM H-D handlebar switches
- Includes:
- male and female Molex terminals
- color matching wire
- wire heat shrink
- Intended for front turn signals mounted on handlebar switch housings
- De-pin factory harness connector and install
- No crimping necessary
- Made in the U.S.A.
Fitment
-
(12″ 11-Up Softail, ’12-Up Dyna, and all ’14-Up Models except V-Rod and Touring)
